Page 21

9.0 Operating Instructions
The spa control system has automatic functions that operate upon start-up
and normal operation to protect the system. Upon power up, the readout
displays the following information:
1. Control panel displays current software release
(e.g. 5.54), then;
2. Control panel displays “888” and all indicator LEDs are lit,
permitting visual inspection of all display segments and
indicator lights for proper operation.
3. After the initial start-up sequence ends, the actual water
temperature is displayed. If water temperature at this
time is less then the factory default temperature setting of
100°F (38°C) and the spa is set to either standard
filtration/heating mode “F1 - F3” (page 23), the heater
will turn on and run until the water temperature rises
to the factory setting, then turn off. Note: it is common for the heater to
turn on after the spa is first filled because tap water is
often very cold.

9.1 Setting Water Temperature

The spa’s thermostat provides optimum control of water
temperature. The temperature setpoint (set temperature) can
be adjusted from 65°F to 104°F (18°C to 40°C). To raise the
set temperature, press the WARmER ( + ) button. To lower
the set temperature, press the COOLER ( - ) button. Note:
The first press of either WARmER ( + ) or COOLER
( - ) button displays the set temperature.

9.2 Activate pumps

The JETS 1 button activates the functions of the main
2-speed jets pump. The first press activates pump 1 in low
speed, the second press activates high speed, and the third
press shuts the pump off. The JETS 2 button (Burlington
models only) controls jets pump 2 which only operates in high
speed. Both pumps have a twenty-minute default when
manually activated.
1.
2.
3.
JETS 1
JETS 2