Sundance Spas 680 10.0 Automatic Filtration Cycles

10.0 Automatic Filtration Cycles

The control system activates a programmable “standard” or “economy”

filtration cycle to remove debris from your spa. These cycles use the low

speed pump, skimmer basket, and filter cartridge quickly clear “skim” the

water of debris and minimize their “bathtub ring” affect. Apart from their

filtration benefit, each mode also effects the operation of your spa’s heat-

er. Refer to sections 10.1 and 10.2 below for additional information.

Standard filtration/heating modes are typically selected by customers in

cold climates where heat up times are extended due to lower ambient

temperatures. In these modes, the water temperature is regulated by the

set temperature, low-speed pump, and heater which tur ns on as needed.

After the programmed set temperature is reached, the heater and pump

turn off, only to turn back on at the next programmed filtration/heating

cycle or during a heat call.

Economy filtration/heating modes are typically selected by customers in

warm climates where heat up times are minimized due to higher ambient

temperatures. In these modes, the water temperature is regulated by the

set temperature, low-speed pump, and heater only while a programmed

filtration/heating cycle is running. Note: these modes consume less

energy than standard modes F1 - F3 ou tlined above.

These modes are designed for use during spa service or to prevent

unauthorized use.

Press and hold both control panel WARmER ( + ) and

COOLER ( - ) buttons at the same time, then release. Then