Sunfire HRS-8 Control Panel Features, 5 6 7 8 9, Power Indicator, Power Switch, AC Line Fuse

Control Panel Features

56 7 8 9 10 1

3

2

4

1. Power Indicator

This light is bright when the subwoofer is on, and dim when the subwoofer is in standby mode.

2. Power Switch

Press the top of this rocker switch to turn on the subwoofer.

The subwoofer has an automatic signal-detection circuit. After approxi- mately fifteen minutes with no signal, the subwoofer will go into its quiet standby mode. The presence of an audio signal will turn it back on.

4. AC Line Fuse

The subwoofer is supplied with a conservative slow-blow type fuse to protect the electronics. If this fuse fails, replace it with the exact same type and current rating for your local AC voltage, as marked on the control panel near the fuse holder.

Note: Always unplug the power cord from your AC outlet before removing the fuse. To replace or inspect the fuse, use a small flat-

ended screwdriver to gently pry out the fuse carrier and fuse.

Normally you can leave the switch on, and let the subwoofer turn on when a signal is present, or off when it's not.

At night, or if you go out, or on vaca- tion, you can press the bottom of the power switch to turn the subwoofer off.

3. IEC Power Connector

The subwoofer comes with a detach- able linecord that attaches here. Make sure it is firmly pushed into place. Connect the other end to an AC outlet that is properly configured for the type of plug and has the correct voltage for your model.

5. Speaker-Level Inputs

If you are using a receiver which only has speaker-level outputs, you can connect it using the speaker-level inputs (see the hookup diagram on page 14). They can accept bare wire, banana, or dual-banana connectors.

If you experience excessive noise or hum using the line-level inputs, try us- ing the speaker-level inputs. This may lower the background noise level.

User's Manual