Wall-mounting the

HRS-SAT4BIP

The HRS-SAT4C comes with a wall- mount template to help mark the correct position for the two mounting screws. It is recommended that you get at least one of the screws into a wall stud, if possible. If this is not possible, then two dry wall anchors and screws are supplied.

1.Use a studfinder to find the location of a suitable wall stud.

2.Position the wall-mount template so that one of the holes is over the wall stud centerline, at the right height. Use a level to make sure that the two holes are horizontal (or vertical, if that is your preference).

3.Mark the wall with a pencil in the location of the two holes, and remove the template.

4.Put on your safety glasses. With a 5/16" drill bit, drill through the dry wall at each mark, without drilling into the wall stud. Remove any dust.

5.For holes into a wall stud, screw in the supplied woodscrew into the wall stud by hand, until the head is sticking out approximately 1/8".

6.For holes into dry wall, press a dry wall anchor into each hole, and gently tap them in flush. Tighten the screws by hand, until the heads are sticking out approximately 1/8".

7.To reduce the chance of the loud- speaker vibrating against the wall, place the supplied anti-vibration pads in two locations on the rear panel as shown.

High Resolution Series HRS-SAT4BIP

Anti-vibration pads

8.Connect your speaker wires to the back of the loudspeaker, making sure of the correct polarity. Secure the wires so their weight is not pull- ing against the terminals.

9.Hold the loudspeaker in place, so the keyholes line up with the screws on the wall. Make sure that the screwheads are securely in the keyhole slots. If the loudspeaker feels loose, drive the screws in fur- ther and remount the loudspeaker.

User's Manual

Page 9
Image 9
Sunfire HRS-SAT4BIP user manual Wall-mounting