SUNIX NCCI Co., Ltd.
TEL : +886-2-8913-1987
Email : info@sunix-ncci.com.tw
If there are more than two boards installed, device nameing convention table as below.
Board Number Device Name
1st board ttySMX0 ~ ttySMX7
2nd board ttySMX8 ~ ttySMX15
3rd board ttySMX16 ~ ttySMX23
4th board ttySMX24 ~ ttySMX31
7. To dump information for those serial ports, do command as below
# smxdump
This will show the info about those serial ports, the result should be like this
================ Found 6 SUNIX port, list informations below ===============
ttySMX0 --
RS-232 (bus:2 device: 1) , base address = a000, irq = 169
ttySMX1 --
RS-232 (bus:2 device: 1) , base address = a008, irq = 169
ttySMX2 --
RS-232 (bus:2 device: 1) , base address = a010, irq = 169
ttySMX3 --
RS-232 (bus:2 device: 1) , base address = a018, irq = 169
ttySMX8 --
RS-422/485 (bus:2 device: 2) , base address = a800, irq = 177
ttySMX9 --
RS-422/485 (bus:2 device: 2) , base address = a808, irq = 177
======================================================================
8. To build softlink for device node, do as below
# snxlink
9. Use snxterm to test those installed serial ports.
# snxterm