4
A s s e m b l y I n s t r u c t i o n s 
ASSEMBLY INSTRUCTIONS
REQUIREMENTS
Failure to meet requirements listed below could result in serious bodily harm.
•Wall mount should be installed by a skilled tradesperson. Installation of the wall mount by someone unskilled will void Sunrise warranty and may cause serious injury or damage.
•Every month a maintenance check should be done to ensure the rail is level (see “Maintenance” in this manual).
•Protect the Easytrack System and its accessories during transport.
•Wall Requirements:
WOOD STRUCTURE – minimum 2” X 3” Studs
CONCRETE STRUCTURE
•Do no install if wall does not meet requirements.
•Do not install on a wall with a steel structure.
BEFORE YOU BEGIN
Read “Requirements” and “Important Safeguards” before attempting to assemble the Easytrack System.
1.Survey the room where you plan to install the Easytrack Wall Mount. Make sure the room meets all the specifications outlined in “Requirements”.
2.Use the measurements below to determine the best place to put the Easytrack System:
a.Over a bed – approx.
b.Over a tub – approx.
c.Allow 36” (915 mm) of open area for transfer working space (Figure 2).
d.Allow a minimum of 53” (1340 mm) from the bottom of the rail to the top of any object to be transferred over (Figure 3).
3.Transfers should only take place under the Easytrack rail (Figures 4 & 5).
4.The Wall Mount may be installed on either a concrete wall or
5.Wall Mount must be positioned on the wall to ensure the angle between the wall and the rail will be more than 30° (Figure 7).
1
2
3
53"
(1340mm)
4
20"
(510mm)80.2-130"
5
studs
6
wall mount plate
| Maximum angle |
| 7 |
|
|
|
|
|
|
| 30° | 30° |
| |
|
|
|
|
|
|
|
|
|
|
Wall Mount Assembly
