Model Number SLCASA-CVR | Emerson instruction

Linear Power Cover Instruction Manual

Model Number: SLCASA-CVR

Power Supplies Affected

SLS-05-030-1T, SLS-12-017T, SLS-24-012T

What’s Included

•Part A Cover

•Two Plastic Screws M3x6 mm

•Two Self-tapping Screws M3x6 mm

•Instruction Manual

Assembly Instructions for Cover Installation

PartA

Cover

-TB

-000

-12

SLO

FIGURE 2

1.	Locate the mounting holes as shown in Figure 2.
2.	Attach SLO-12-000-TB tightly against the inner side of the cover.
3.	Position the mounting holes and tighten the screws with 8 kg torque.

Power

ChassisSupply

Self-tapping screws (2 qty) M3x6 mm

* *

Plastic screws (2 qty) M3x6 mm

*Must use plastic only

4. Assemble the two wires coming out of the SLO-12-000-TB. On the terminal

block, the white wire goes to the “+” and the black wire goes to the “-”.

Notes

1.	Be careful while assembling the cover, so that no parts on the PCB are
	damaged.
2.	When tightening the screws, make sure the torque is 8 kg.

1.Position the Part A Cover so that it overlaps the exterior surface of the Power Supply Chassis.

2.Line up the Part A Cover mounting holes with the Power Supply Chassis mounting holes. Be careful not to pinch the wires.

3.Secure with the provided screws as shown in Figure 1.

3. Derate power supply by 15% with cover installed.

Technical Support

U.S.: (800) 377-4384

International: (847) 268-6651

E-mail: tech@solahd.com

Part Number: A272-108 Rev 3

September 22, 2008