Sunrise Medical Quickie P120 FLIP-BACK Armrests, To Flip Armrest Back, To Height Adjust

I X . S E T - U P , A D J U S T M E N T & U S E

I X . S E T U P , A D J U S T M E N T & U S E

I. FLIP-BACK ARMRESTS

1.Notes:

Non-removable, we install this armrest at the factory.

2.To Flip Armrest Back:

Push latch lever (1) toward tube to “flip” or tilt armrest back.

J. FLIP-BACK HEIGHT- ADJUSTABLE ARMRESTS (OPTIONAL)

1.Notes:

1

K. REAR WHEEL LOCKS (OPTIONAL) When requested, rear wheel locks are installed by Sunrise.

1.Note: Use a torque setting of 70-80 inch- pounds to tighten wheel lock bolts.

2.To Adjust:

a.Use a open-end wrench to loosen two bolts (8) on top clamp (6).

b.Turn each bolt counter-clockwise one- quarter turn; (Alternate, to keep bolts from binding).

6

8

7

Armrest are removable; you can adjust the height of the armrest pad.

2.To Flip Armrest Back:

Push latch lever (2) toward tube to “flip” or tilt armrest back.

3.To Remove:

a. Push latch lever (2) toward tube and “flip” or tilt armrest back.

b. Pull up on armrest pad.

4.To Height Adjust:

a. Press release lever (5)

b. Pull up on the armrest pad to the desired location.

5

3

2

4

c. Adjust (6) clamp toward rear wheel until lock arm (7) embeds in tire at least 1/8” when locked.

d.Alternate as you retighten bolts (8).

e.Repeat steps on other side.

5.To Replace:

a.Tilt armrest back and insert rear arm tube (3) into receiver (4).

b.Tilt armrest forward.This will engage pin to secure rear arm tube.

c. Push armrest down until front tube locks in place.

930373 Rev. B 28 29 930373 Rev. B