X7DB8/X7DBE User's Manual
~3VDC. If it does not, replace it with a new one.
3.If the above steps do not fi x the Setup Confi guration problem, contact your vendor for repairs.
NOTE
If you are a system integrator, VAR or OEM, a POST diagnostics card is recommended. For I/O port 80h codes, refer to App. B.
Memory Errors
1.Make sure the DIMM modules are properly and fully installed.
2.Determine if different speeds of DIMMs have been installed and verify that the BIOS setup is confi gured for the fastest speed of RAM used. It is recom- mended to use the same RAM speed for all DIMMs in the system.
3.Make sure you are using the correct type of DDR2 Fully Buffered (FBD) ECC 533/667 SDRAM (*recommended by the manufacturer.)
4.Check for bad DIMM modules or slots by swapping a single module between four slots and noting the results.
5.Make sure all memory modules are fully seated in their slots. As an interleaved memory scheme is used, you must install two modules at a time, beginning with Bank 1, then Bank 2, and so on (see Section
6.Check the position of the 115V/230V switch on the power supply.
3-2 Technical Support Procedures
Before contacting Technical Support, please take the following steps. Also, note that as a motherboard manufacturer, Super Micro does not sell directly to
1.Please go through the ‘Troubleshooting Procedures’ and 'Frequently Asked Question' (FAQ) sections in this chapter or see the FAQs on our web site (http://www.supermicro.com/TECHSUPPORT/techsupport.htm) before con- tacting Technical Support.
2.BIOS upgrades can be downloaded from our web site at http://www.supermicro.com/techsupport/download.htm.
Note: Not all BIOS can be flashed depending on the modifications to the boot
