Harness
Dia gram | HN0397 revA ecr 4452 03/2004 |
|
| Yellow/Red | Yellow/Red |
|
| Green/Orange |
| Green/Orange | Green/Orange |
|
| Yellow |
|
| Black |
| Yellow | Black |
| Black | Gray |
| Gray | Gray |
Heat shrink tubing
HN0418 rev A ecr 5609 8/05
Yellow
Yellow | Yellow |
Sync Port
Lights Sync Stbd
Ground
+14V
Trouble Shooting
Trouble | Inspection | Diagnosis | Action |
| ||
Gauge Sticks | A. Backclamp may | 1. Slightly loosen nuts | 1. | If gauge works and is |
| |
| be too tight. | holding backclamp. |
|
| not loose in panel, |
|
|
| Check operation. |
|
| continue using gauge. |
|
|
|
|
|
|
|
|
|
|
| 2. | If gauge continues to |
| |
|
|
|
|
| stick, replace gauge. |
|
Gauge | A. Is power applied to |
Inoperative | gauge? |
1.Switch the instrument power supply switch on and off. As power is supplied the pointer should jump slightly.
1.Check wires to check they were installed on the correct terminals and power is actually supplied to gauge.
2If pointer jumps (indicating power supplied), check for signal from engine. If signal exists, replace tachometer.
Trouble shooting continued next page.