SV Sound STA-1000D, STA-800D Volume, High Pass Filter (HPF) Adjustment (STA-1000D)

SVSound™

STA-800D/1000D Equipped Subs

There are up to eight Functions within the top-level menu structure that allow conﬁguration of the subwoofer.

These Functions include:

 •Volume(dB)

 •Highpasslteradjustment(disable/enable,frequency,andslope)

 •Lowpasslteradjustment(disable/enable,frequency,andslope)

 •Phasesetting(degrees)

 •Highpassdelay(milliseconds)

 •Roomcompensation(disable/enable,frequency,andslope)

 •Subwoofertune(sealed,16Hz,20Hz)

 •ParametricEQ(PEQ)1andPEQ2(frequency,levelandQforeach)

The following section describes each Function in detail, along with its use and available settings/values. Once

familiar with the operation of the IFC on the SVS subwoofer, there is a block-level diagram included at the end

of the section if needed for quick reference.

Volume

From the IFC WELCOME screen, single-click the IFC knob and the display should read “MENU/VOLUME”.

Single-click the IFC knob to select the Volume Function. Turn the IFC knob clockwise to increase the Volume of

thesubwoofer,orcounter-clockwisetodecreasethevolume.Single-clickORdouble-clicktoreturntothetop-

levelmenu.Therangeofadjustmentofthiscontrolis-100to0dBin1dBincrements.

High Pass Filter (HPF) Adjustment (STA-1000D)

Theoutput(bothsingle-endedRCAandBalanced)canhaveaHighPassFilterapplied.TheHPFFunctioncontrolsthe

HighPassfrequencyandtheassociatedslopeoftherollofffortheoutputconnectorsontheSTA-1000D.

From the IFC WELCOME screen, single-click the IFC knob and rotate the IFC knob one click clockwise so the display

reads“MENU/HIGHPASS”.Single-clicktheIFCknobtogettotheHPFFunctionmenu.IftheHPFisdisabled,ames-

sage to that effect will be displayed.

IftheHPFisdisabled,turntheIFCknobclockwise whichwilldisplaytheHighPassFrequencysubmenu.TosettheHPF

frequency to a value other than what is currently displayed, single-click the IFC knob and then rotate the knob clockwise

orcounter-clockwisetosetthedesiredfrequency.Frequencychoicesinclude31,40,50,63,80,100,and125Hz.

Single-clicktheIFCknobtoreturntotheHighPassFunctionmenu.TurntheIFCknobtomovetotheHighPassSlope

submenuandsingle-clicktochangetheslopevalue.TheHighPassSlopedenestheslopeoftheattenuation

curvebelowtheselectedfrequency.Twochoicesareavailable;12dBperoctaveand24dBperoctave.

Integrated Function Controller