SVAT Electronics GX5203 Operating Modes, Scan, Auto, Manual, Connecting To A Vcr

SVAT ELECTRONICS

now you can see

OPERATING MODES

The system can be set to operate in one of 3 modes: SCAN, AUTO or MANUAL. The desired operating mode can be selected using the buttons on the front panel of the monitor.

Scan

Pressing the SCAN button places the system in scan mode. The monitor's screen will go blank (standby mode) while the system continuously scans active cameras. Press the MANUAL or AUTO button to cancel this mode.

Auto

Pressing the AUTO button places the system into auto mode. In this mode, the system automatically rotates through all active cameras. To avoid searching the channels that do not have cameras/transmitters assigned to them, set those corresponding dip switches (located on the back panel of the monitor) to the OFF position.

The dwell/cycle time (time taken to switch between cameras) is preset to four seconds and can be adjusted between 2-30 seconds. To adjust the dwell/cycle time, hold down both the AUTO and MANUAL buttons simultaneously. The monitor will chime for each second it is adding to the dwell time. Release the buttons, and the LED light will flash for each second that was added to the dwell time. Increasing the dwell/cycle time past 30 seconds will revert it back to 2 seconds.

Manual

To view a specific camera on the monitor, press the MANUAL button. The monitor will switch to a different camera each time the MANUAL button is pressed. To avoid searching the channels that do not have cameras assigned to them, set those corresponding dip switches (located on the back panel of the monitor) to the OFF position.

CONNECTING TO A VCR

You can connect a VCR to the system to allow recording of your camera footage. To connect the receiver to a VCR for recording purposes, use the RCA adapter cable and connect the appropriate ends to the A/V Out jack on the receiver, and the other corresponding ends to the audio and video inputs of the VCR.

GX5203 5