Nighthawk
GE
Setting the Camera Channel | F | Camera Positioning |
Note: If your camera | 1. Find the seam running | 2. Twist the front half of the | 3. Locate the small white |
has a hood, remove | around the middle of | camera | dip switches in the |
the 2 screws first | the camera | to remove the outer casing | upper left region of |
|
|
| the camera |
Cordless Phones/Mobiles
Wireless Internet
Some Electronic Devices
4.Using your fingernail or pen, move the dip switches up or down to change to the appropriate channel
Channel and Frequency Settings
1 | Channel 1 | 1 | Channel 2 |
2 | 2414MHz | 2 | 2432MHz |
1 | Channel 3 | 1 | Channel 4 |
2 | 2450MHz | 2 | 2468MHz |
Note: Wireless and electronic devices such as these can interfere with camera
transmission if they are within the cameras range.
Some wireless devices can
be set to different frequencies. Consult the manufacturer’s manual for details
G | Achieving the highest quality signal |
If you are still receiving interference change the camera’s channel as per step E then switch the receiver to the correct channel
If possible turn off or keep the camera and receiver away from wireless devices
A clear line of sight with little wireless interference will always give you the strongest picture
Walls and floors can also limit range and image results. Place the receiver in a location that is relatively close to the camera’s position
H | General Installation Notes and Tips |
1.Test the camera signal before permanently installing the cameras.
2.Using battery power is only recommended for testing purposes as the cameras do require constant power to operate.
3.IR or night vision will reflect off of glass or windows and overexpose the picture. Try placing cameras in direct line of sight of your subject.
4.Never aim the camera directly at the sun as this can permanently damage the lens.
5.Never submerge the camera in water. Some shelter is recommended such as an awning or eave.