Powering the PenCam On/Off
Powering On the PenCam
1.Push and release the button on the PenCam 1 time.
2.The orange light will turn on.
3.Wait 5 to 10 seconds for the PenCam to load and “boot up”.
4.After the PenCam has finished booting it will automatically begin recording indicated by the blue light.
Push the button 1 time to power on the PenCam
IMPORTANT NOTE: You must wait until the PenCam has finished booting and the light has turned blue before pressing the button again, otherwise there may be data loss or undesired results.
Powering Off the PenCam
1.If the light is blue, push and release the button one time to stop recording and wait until the light turns orange.
2.When the light is orange, push and hold the button to power off the PenCam.
4
Recording and Standby Modes
Standby Mode
When the orange light is on the PenCam is in standby. Push the button 1 time to begin recording. If you are powering on the PenCam it will automatically begin recording, do not push the button while the PenCam is booting.
Recording Mode
The blue light indicates the PenCam is currently recording. Push the button 1 time to stop recording. The PenCam may take several seconds to process and save the recording.
Orange indicates standby mode
Blue indicates currently recording
IMPORTANT NOTE: When stopping a recording push the button only 1 time. The PenCam will write the video to memory. Depending on the length and com- plexity of the video there may be several seconds delay. Do not push the button again during this time or data loss may occur.
Charging the PenCam
The PenCam has a built in
Unscrew the PenCam to reveal the hidden USB port
Charge the PenCam by connecting the hidden USB connector inside the PenCam to a USB port on your computer. The PenCam will flash orange, indicating it is charging. Full charge time is approximately 2 hours.
IMPORTANT NOTE: Before using the PenCam for the first time, connect it to a USB port and charge for the full 2 hours.
5
