Swann SW245-SMD manual Installing the Camera Hood, Replacing or Changing the Lens

Installing the Camera Hood

Installing the Camera Hood

To fit the Camera Hood use a small Philips Head screwdriver to remove the two screws from the top mounting block. Once these are removed, place the hood on top of the camera casing with the slots over the screw holes in the casing. Place the mounting block on top of the hood, then using the screwdriver screw the two screws back into the casing until the hood is firmly secured.

Replacing or Changing the Lens

Replacing or Changing the Lens:

First, make sure the camera hood has been removed, then follow these steps.

(A)Unscrew the front housing of the camera in an anti-clockwise direction

(B)Remove the rubber ring around the camera lens

(C)Carefully remove the LED circuit board from the housing and turn it to one side, taking care of the wires that go from the underside of the circuit board into the camera

(D)Unscrew the lens in a counter-clockwise direction and remove it completely

(E)Once the lens is removed, carefully screw the replacement lens (not included) in a clockwise direction into the lens socket and adjust it for correct focus

(F)When the focus is correct, refit all of the components you have just removed in reverse order. Reverse this procedure if you wish to refit the Standard lens

Note: The Maxi Day/Night Color Camera will automatically change to a black & white image using the Infra-Red LEDs when available light is too low to support a clea color picture.

4