Item # | Part # | Description |
1 | 10113 | Deflector - Spreader |
2 | NB505 | Bolt - |
3 | NB556 | Washer - USS Flat, 5/16 ZY |
4 | NB579 | Washer - Fender, 5/16 X 1 1/4 OD ZY |
5 | 7825Z | Bushing - Lift Bar |
6 | 10051 | Spring - Gate, 12V ATV Spreader |
7 | NB555 | Washer - USS Flat, 1/2 ZY |
8 | 10112TK | Gate - Hopper |
9 | 10111TK | Bracket - Motor Support, Upper |
10 | NB181 | Nut - Nyloc |
18 | 10192 | Washer - Nylon Retainer 5/16" |
20 | 10975 | Tank - Truck Spreader |
Step 1:
Assemble the components as shown. Use the Nylon Retainer Washer (18) to hold the parts together.
Step 2:
Attach the assembly made in Step 1 to the tank (20) by sliding the bolts (2) up through the tank and placing a fender washer (4) over each bolt. Thread a nut (10) over each bolt and tighten securely.
NOTE: To change the amount of material being spread, adjust the hopper gate by pulling on the handle until the desired flow is attained. A scale of one to four has been provided with one being the least amount, and four being the most. Zero will seal the material from being distributed.
