Swisher 11730 owner manual Step

Item #	Part #	Description
9	10111TK	Bracket - Motor Support, Upper
11	10114TK	Bracket - Motor Support, Lower
12	10197	Bolt - Carriage 5/16-18 X 1 GR5
13	10117TK	Shield - Spreader
14	3844	Knob - T, 5/16-18
15	15118	Motor - Spreader 12 VDC CW 2.5"
16	10118	Spinner - Distributor, Spreader

Step 3:

Remove the nuts and snap ring from the motor and place the Lower Motor Support Bracket (11) over the Motor (15). Thread the nuts onto the motor studs and tighten. Slide the Spinner/Distributor (16) over the motor shaft and replace roll pin.

Step 4:

Insert the 5/16” Carriage Bolts (12) into the Lower Motor Bracket (11), through the Upper Motor Bracket (9), and through the Spreader Shield (13). Place the T-Knobs (14) on the bolts (12) and tighten. (The guide of the

Lower Bracket will slide up through the slot in the Upper Bracket).

NOTE: To change the radius of material being spread, simply loosen the T-Knobs and slide the mechanism up (smaller radii) or down (larger radii).