SWR BASS 350 — SPECIFICATIONS
Note: All measurements were taken with a line voltage of 120VAC. All noise specifications are “unweighted.” All voltages and watts are “RMS.” All measurements were taken with tone controls set flat, Aural Enhancer at minimum.
POWER (minimum) 450 Watts @ 2 ohms 350 Watts @ 4 ohms 240 Watts @ 8 ohms
FREQUENCY RESPONSE (Power Amplifier)
SENSITIVITY (full output under clipping, 8 ohms load, 100 Hz)
Passive Input Jack: 38 millivolts
Active Input Jack: 60 millivolts
Power Amplifier (Effects Return Jack “in”): 5 volts
INPUT IMPEDANCE
Passive/Active Input: 800k Ohms
Active Input: 60k Ohms
Effects Return: 27k Ohms
OUTPUT IMPEDANCE
Effects Send: 100 Ohms
Tuner Send: 100 Ohms
Crossover Low and High Outs: 100 Ohms XLR
Balanced Out: .750 Ohms
SIGNAL TO NOISE RATIO:
EQUIVALENT INPUT NOISE: 9 microvolts
DIMENSIONS: 19" W x 3.5" H x 10.125" D
WEIGHT: 21 lbs.
BASS 350 — FRONT PANEL FEATURES
PASSIVE/ACTIVE INPUT JACK
This input jack is designed to accommodate both “passive” instruments, and most “active” instruments. A passive instrument has no
Generally speaking, try this input first. If you hear a small amount of distortion and the preamp clip LED is not activated, try using the Active input jack. If using the Active input does not correct any audible distortion, check the battery in your bass.
2 BASS 350 USER GUIDE