Sylvania 6615LDF Preparation for USE, ANTENNA/CABLE Connection, If YOU have a Jack on the Wall

PREPARATION FOR USE

ANTENNA/CABLE CONNECTION

NOTE

•Cables used here are commercially available.

•For your safety and to avoid damages to the unit, unplug the antenna cable from the ANT. jack before moving the unit.

- ANTENNA/CABLE CONNECTION

[Rear of this unit]

from Cable Company or Satellite Antennna

RF Cable

IF YOU HAVE A JACK ON THE WALL

Connect the TV to the wall-mounted antenna jack with on RF cable (commercially available).

IF YOU HAVE A WIRED CABLE

Connect the TV to the wired antenna cable.

NOTE

•Before plugging the antenna into the ANT. jack of the unit, check that the pin is not bent. If it is bent, straighten the pin as illustrated, then plug the pin into the ANT. jack of the unit.

Bent pin

Cable Plug

(Needs to be	(Straight pin)
straightened)

- CABLE/SATELLITE BOX CONNECTION

[Rear of this unit]

WHEN USING CABLE BOX/SATELLITE BOX

Cable Box

or Satellite Box

OUT IN

75-ohm Coaxial Cable

If your cable service supplies you with a converter box or if you use a satellite system, you can use the basic connection shown above.

Channel selection must be made with the converter box or satellite box. This means that channels cannot be changed using the remote control of this unit.

from Cable Company or Satellite Antenna

NOTE

For CATV system installer:

•This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that provides guidelines for proper grounding and in particular, specifies that the cable ground shall be connected to the grounding system of the building as close to the point of cable entry as practical.

- 10 - EN