CHANNEL SET UP
TV/VCR
You can program the tuner to scan all the channels you receive in your area.
NOTE: Channel memory programming is NOT needed when connected to a cable box or satellite box. Just select the TV/VCR/DVD channel selector
DELETING (OR ADDING)
CHANNEL(S)
TV/VCR
The channels you no longer receive or seldom watch can be deleted from the memory. (Of course, you can add the deleted channel into the memory again.)
to the output channel of the cable box or satellite box (Ex CH3), then select the channel to be viewed on the Cable Box or Satellite Box.
Make sure ...
•Press the POWER button to turn on the TV/VCR/DVD.
1Select “CHANNEL SET UP”
Press the SETUP button on the remote control.
Press the Arrow button K or L to point to “CHANNEL SET UP”. Then press the ENTER button.
– M E N U –
TIMER PROGRAMMING PICTURE CONTROL SETTING CLOCK
BCHANNEL SET UP USER’S SET UP
TIME SEARCH
1Select “CHANNEL SET UP”
Press the SETUP button on the remote control.
Press the Arrow button K or L to point to “CHANNEL SET UP”. Then press the ENTER button.
– M E N U –
TIMER PROGRAMMING PICTURE CONTROL SETTING CLOCK
BCHANNEL SET UP USER’S SET UP
TIME SEARCH
2 Select “ADD/DELETE CH” | – CHANNEL SET UP – |
Press the Arrow button K or L to | B ADD / DELETE CH (CATV) |
point to “ADD/DELETE CH”. | AUTO CH PROGRAMMING |
Press the ENTER button. |
|
2Begin auto ch programming
Press the Arrow button K or L to point to “AUTO CH PROGRAM- MING”.
Then press the ENTER button. The tuner scans and memorizes all the active channels in your area.
– CHANNEL SET UP –
ADD / DELETE CH (CATV)
BAUTO CH PROGRAMMING
3Enter the desired channel number
Press the Arrow button K or L until your desired channel number
appears. (You can also use the | 08 | |
number buttons or the CHANNEL | ADD / DELETE | |
button K or L to enter it) | ||
|
(Example: CH8)
• You must precede |
with a zero (Example: 02 ... 09). |
3After scanning
The tuner stops on the lowest memorized channel.
•When AUTO CH PROGRAMMING is activated where there is no TV signal input, “NO TV SIG- NALS” will appear on the display after the com- pletion of the channel scanning.
•The TV/VCR/DVD may recognize TV channels to be CATV channels by the receiving conditions. In this case, try auto ch programming again in the fine receiving conditions.
• When selecting cable channels which are higher |
than 99, press the +100 button first, then press the |
last two digits. (Example: to select channel 125, |
first press the +100 button then press “2” and “5”). |
4Delete (or add) it from (into) memory
Press the ENTER button. The channel number changes to light red. The channel is deleted from memory.
•To delete another channel, repeat steps [3] and [4].
•If you press the ENTER button again, the channel is memorized again.
Added channel: Light blue.
Deleted channel: Light red.
5Exit the channel setup mode
Press the SETUP button on the remote control to return to TV mode.
NOTE: To confirm that channel(s) has been deleted or added, press the CHANNEL button K or L.
- 18 - | EN |
1C29
