–13 –EN
1L25

CONNECTING TO A TV WITH A/V TERMINALS

DVD/VCR VCR
AUDIO OUTAUDIO IN
VIDEO OUTVIDEO IN
L
ANT-IN
ANT-OUT
R
L
R
To VIDEO OUT jack
To VIDEO INPUT jack
To Right (red) and Left (white)
Antenna/Cable signal
To ANT. IN
of TV
To AUDIO INPUT jacks To AUDIO OUT jacks
A/V-compatible or
wide screen TV
S-VIDEO
OUT
COMPONENT
VIDEO OUT AUDIO
OUT
DVD
Y
L
R
DIGITAL
AUDIO OUT
COAXIAL
Cb
Cr
[Fig. 1]
Notes
¡Connect the DVD/VCR COMBINATION UNITdirectly to a TV. If the A/Vcables are connected into a
VCR first, picture may be distorted due to the copy protection system.

CONNECTING TO ATV WITHOUT A/V TERMINALS

1. Disconnect the AC power cord of the TVfrom the
AC outlet.
2. Disconnect the antenna or cable from the TV.
3. Connect the antenna or cable to the ANT-IN jack of
the DVD/VCR COMBINATION UNIT.
4. Connect theDVD/VCR COMBINATION UNIT to
the TVusing the RF cable.
5. Plug the AC power cords of the DVD/VCR COM-
BINATION UNITand TV into the AC outlets.
UHF/VHF
[VHF/UHF
combination antenna] [Back of the DVD/VCR]
IN OUT
[Cable box or satellite box]
OR
[Indoor antenna] [Back of the
UHF/VHF combination TV]
RF cable
(supplied)
From Cable or
Satellite Company
OR
DVD/VCR VCR
AUDIO OUTAUDIO IN
VIDEO OUTVIDEO IN
L
ANT-IN
ANT-OUT
R
L
R
Note to CATVsystem installer
This reminder is provided to call the CATVsystem installer’s attention to Article 820-40 of the NEC that pro-
vides guidelines for proper grounding and, in particular, specifies that the cable ground should be connected
to the grounding system of the building, as close to the point of cable entry as practical.
HOOKUPS
CAUTION:
¡Be sure to turn off the DVD/VCR COMBINATION UNITand equipment to be connected.
¡Read through the operation manual for the equipment to be connected.
¡Be sure that the colors of the jacks and plugs match up when using VIDEO/AUDIO cables.
¡Be sure to keep the DVD/VCR COMBINATION UNITconnection cables separate from the TV antenna cable
when you install the DVD/VCR COMBINATION UNIT, because it may cause electrical interference when you
are watching television programs.

RF OUTPUT CHANNEL for DVD/VCR

1. Connect the DVD/VCR COMBINATION UNITto a TV using RF cable (see above steps).
2. Select channel 3 on your TV.
3. Press PLAY.
¡If noise appears, change the RF output channel of the DVD/VCR COMBINATION UNITto channel 4 by
pressing PLAYon the VCR for 3 seconds during playback.
¡
There is case that the RF output channel does not change by situation (For example, when you adjust tracking using
CHANNEL ).
In this case, stop the playback, and start the playback again. After that, press PLAYon the VCR for 3 seconds.
¡
If there is a power failure or the DVD/VCR COMBINATION UNITis unplugged for more than 30 seconds, the RF
output channel setting will return to CH3
.
( )
H9435UD.qx33 03.3.18 10:13 AM Page 13