Sylvania LC190SL1 Supplied Accessories, Symbols Used in this Manual, Attaching the Base, English

Supplied Accessories

Owner’s manual	Quick Start
(1EMN26205)	(1EMN26266)

Remote control (NH001 UD)

OK

VOLCH

1	2	3
4	5	6
7	8	9
PREV CH	0	.

Batteries	Screw kit
(AAA, 1.5V x 2)	for attaching the base
	(1ESA19876)
AAA
AAA

•If you need to replace these accessories, please refer to the part No. with the illustrations and call our toll free customer support line found on the cover of this manual.

Note

•If you lose the screws, please purchase M4×12 Phillips head screws at your local store.

Symbols Used in this Manual

The following is the description for the symbols used in this manual. Description refers to:

ATSC : Digital TV operation

NTSC : Analog / Cable TV operation

•If neither symbol appears, the operation is applicable to

both.

English

				INTRODUCTION
Attaching the Base
You must attach the base to the unit to have it as a table top
unit. Be sure the front and rear of the base match the proper
direction.
1 Spread a thick and soft
		cloth over a table as
				PREPARATION
		shown.
		Place the main unit face
		down onto it. Make sure
		not to damage the screen.
		Insert 2 hooks under the
		bottom of the main unit
		into base holes. (shown by ➁	➀	WATCHING
		arrow ➀), then move the
		base in the direction as
		shown by arrow ➁ until it
		stops and the 3 mounting		TV
		holes are aligned. Make
		sure not to put the AC
		power cord between the		OPTIONAL
3 Drive Phillips pan screws
		base and the unit.
		into the 3 threaded holes		SETTING
		until they are tight.
		at the bottom of the base
To remove the base from this unit				TROUBLESHOOTING
		Unscrew the Phillips pan screws on step 3
		After the screws are removed, move the base in the opposite direction as
		shown by arrow ➁ on step 2, then pull the base up toward the rear of the
		unit. Be careful not to drop the base when you remove it.
	Note
		When attaching the base, ensure that all screws are tightly fastened. If the
		base is not properly attached, it could cause the unit to fall, resulting in		INFORMATION
		upward. If it's not upward, the 2 hooks don't fit in the base.
		injuries as well as damage to the unit.
		Make sure to use a table which can support the weight of this unit and is
		larger than this unit.
		Make sure the table is in a stable location.
		When attaching the base, ensure that FRONT ↑ written on the base is

Fixing the Unit on Your Furniture

Screw this unit on your furniture tightly using wood screws

(not supplied) in the 2 holes at the back of the base as shown.

Recommended screw dimension : 5.1 x 20 mm

rear of this unit

Note

•When you remove this unit make sure to unscrew the wood screws from your Wood Stand, Furniture and other wood item.

5

EN