INITIAL SETTING
LANGUAGE
You can change the language (English, Spanish, French) displayed on the main menu.
(Refer to “Language Selection” on page 14.)
5Auto Channel Scan
If you switch wires (e.g., between antenna and CATV) or if you move the unit to a different area after the initial setting, or if you restore the DTV channel you deleted, you will need to perform auto channel scan.
Before you begin:
Make sure if the unit is connected to antenna or cables.
1Press [SETUP] to display the main menu.
Note:
•After setting “Auto Channel Scan”, using [CH. K/L] on the remote control skips unavailable programs automatically.
•If you connect the cable system directly, contact the CATV installer.
•If you press [POWER] or [SETUP] during auto channel scan, the setting will be canceled.
•Channel settings will be saved even if the power fails.
•If you need the English menus instead of the Spanish or French menus you are having, press [SETUP]. Use [Cursor K/L] to select “IDIOMA” or “LANGUE”, then press [ENTER]. Use [Cursor K/L] to select “English”, then press
[ENTER]. Press [SETUP] to exit the main menu.
•With regard only to the digital channel, even after the scanning is completed if you unplug the AC power cord before turning off the unit by pressing [POWER], the channel setting may be lost.
2Use [Cursor K/L] to select “CHANNEL” , then press [ENTER].
or
3Use [Cursor K/L] to select “Autoscan”, then press [ENTER].
5Language Selection
You can choose English, Spanish or French as your on-screen language.
1Press [SETUP] to display the main menu.
2Use [Cursor K/L] to select “LANGUAGE”, then press [ENTER].
or
or
Channell
Autoscan
Channel List
Manual Register
Antenna |
Use [Cursor K/L] to select an appropriate option, then press [ENTER].
3Use [Cursor K/L] to select “English”, “Español” or “Français”, then press [ENTER].
or
Autoscan
Autoscan will rescan all channels. | Back |
This may take a while to complete. | Air |
| |
Select the destination of "ANT.IN" jack. | Cable |
| |
| Cable |
Air | 1 hour |
or
Language
Select the language for setup display. | English | ||
|
| Español | |
Elija el idioma de ajuste. | |||
|
| Français | |
Sélectionner langue écran config. | |||
Cable Or
ANT.IN
•When aerial antenna is connected, select “Air”.
•When connected to CATV, select “Cable”.
•Scanning and memorizing of channels start automatically.
Now the system is scanning for channels, please wait.
72%
| Analog channels |
| 10ch |
|
|
|
|
|
|
|
|
|
|
|
| ||
| Digital channels |
| 6ch |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| SETUP | Exit | |||
|
| ||||
|
|
|
|
|
|
4Press [SETUP] to exit.
• When the scanning and memorizing are completed,
14the lowest memorized channel will be displayed.
EN
