Sylvania SRC21134, SRC21194 owner manual Normal Playback, Inserting a Cassette, Precautions

FM MODE (SRC21134 only)

This function enables you to receive FM radio broad- casting.

1Set the FM mode

Press the TV/FM button on the

remote control. The radio frequency FM 88.0 MHz appears on the TV screen.

2Select the radio frequency you want to receive

Press the CHANNEL K or L button until your desired radio frequency appears.

NOTES:

•FM mode is not available for model SRC21194.

•The radio frequency indication repeats to appear and disappear.

•You can not record the FM radio wave broadcast- ing.

•If you receive a weak radio signal, you may change the FM Antenna mode to INT(internal) or EXT(external) by following the step below.

1)Press the MENU button. Press the PLAY/K or STOP/L button to point to “CHANNEL SET UP”. Then, press the F.FWD/B button.

2)Press the PLAY/K or STOP/L button to point to “FM ANTENNA”. Select [INT] or [EXT] using the F.FWD/B or REW/s button.

PLAYBACK

This TV/VCR will operate with any cassette that has the mark. For best results, we recommend the use of high-quality tapes. Do not use poor quality or damaged tapes.

INSERTING A CASSETTE

Insert the cassette in the direction as shown. Push in gently, but continuously, on the center-back of the cassette until it is drawn into the TV/VCR. The TV/VCR will automatically turn on.

Window

CORRECTWRONG

PRECAUTIONS

•Avoid moisture. Moisture condensation may occur on the tape if it is moved from a cold place to a warm place or visa versa. Before using a tape with these conditions, to avoid damage of the tape and your TV/VCR, wait until the tape has warmed to room temperature and the moisture has evaporated.

•Avoid extreme heat, high humidity and magnetic fields.

•Do not tamper with the cassette mechanism.

•Do not touch the tape with your fingers.

NORMAL PLAYBACK

Make sure ...

•TV/VCR power must be turned on.

1Insert a prerecorded tape

If the erase-protection tab has been removed, the TV/VCR will start playback automatically.

2 To begin playback PLAY B

Press the PLAY button.

Note: If any menu is activated on the screen, the PLAY button does not function. Press the MENU but-

ton to clear the menu, then press the PLAY button. If a tape is already in the TV/VCR with the power off, do either of the following:

A)Press the PLAY button on the TV/VCR. Power will automatically turn on and playback will start.

B)Press the POWER button on the remote control to turn the TV/VCR on, then press the PLAY button on the remote control and playback will start.

3 To stop playback STOP

Press the STOP button when play- back is completed.

- 17 - EN

9I03