Sylvania SRC2213W, SRC2419 owner manual Preparation for USE, ANTENNA/CABLE Connections

PREPARATION FOR USE

ANTENNA/CABLE CONNECTIONS

From Cable System or Satellite Dish

Satellite Box or	OUT
	IN
Cable Box
(Not supplied)

Rod Antenna (Supplied with 13” model only)

VHF/UHF Antenna (Not supplied)

VHF Antenna (Not supplied)

From

Cable System

75-ohm Coaxial	or
Cable (Not supplied)

	UHF Antenna
or	(Not supplied)

VHF/UHF or Combiner

(Not supplied)

ANT.

or Flat twin-lead cable

VHF/UHF COMBINED ANTENNA

The VHF/UHF Rod Antenna (supplied with 13” model only) is detachable. Insert the stem of the antenna into the hole on the upper-back portion of the TV/VCR. Connect the VHF/UHF Rod Antenna or VHF/UHF Combination Antenna to the ANT. termi- nal of the TV/VCR as shown in the diagram. For the best reception, fully extend the VHF/UHF Rod Antenna and make the necessary adjustments. (Avoid touching the top section when adjusting.)

NOTE:

Before connecting the Rod antenna into antenna ter- minal, check that the pin is not bent. If it is bent, straighten the pin as illustrated, then plug the pin into antenna terminal.

VHF/UHF SEPARATE ANTENNAS

In some areas it will be necessary to use an outdoor antenna.

CABLE WITHOUT CONVERTER/ DESCRAMBLER BOX

Use this connection if your cable system connects directly to your TV/VCR without a converter box. By using this connection you can:

1)Use the TV/VCR Remote Control to select channels.

2)Program one or more unscrambled channels for Timer Recording.

NOTE: This unit will ONLY record and view the same channel.

Bent pin

Cable Plug

(Needs to be straightened) (Straight pin)

NOTE:

The connection of an Rod antenna may not always give acceptable TV reception.

CABLE WITH CONVERTER/ DESCRAMBLER BOX OR SATELLITE BOX

If your cable service supplies you with a converter box or if you use a satellite system, you can use the basic connection shown in the diagram.

By using this connection you can also record scram- bled channels. However, channel selection must be made with the converter box or satellite box. This means that channels cannot be changed using the TV/VCR Remote Control. Unattended timer record- ing is limited to one channel at a time.

Note to CATV system installer:

This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connect- ed to the grounding system of the building as close to the point of cable entry as practical.

- 9 - EN

9I03