Sylvania SRD3900 owner manual Hookups, Connecting to a TV Without A/V Terminals

HOOKUPS

CAUTION:

¡Be sure to turn off the DVD/VCR COMBINATION UNIT and equipment to be connected. ¡Read through the operation manual for the equipment to be connected.

¡Be sure that the colors of the jacks and plugs match up when using VIDEO/AUDIO cables.

¡Be sure to keep the DVD/VCR COMBINATION UNIT connection cables separate from the TV antenna cable when you install the DVD/VCR COMBINATION UNIT, because it may cause electrical interference when you are watching television programs.

CONNECTING TO A TV WITHOUT A/V TERMINALS

1.Disconnect the AC power cord of the TV from the AC outlet.

2.Disconnect the antenna or cable from the TV.

3.Connect the antenna or cable to the ANT-IN jack of the DVD/VCR COMBINATION UNIT.

4.Connect the DVD/VCR COMBINATION UNIT to the TV using the RF cable.

5.Plug the AC power cords of the DVD/VCR COM- BINATION UNIT and TV into the AC outlets.

[VHF/UHF	[Indoor antenna]	[Back of the DVD/VCR]
combination antenna]				[Back of the
				UHF/VHF combination TV]
	OR	DVD/VCR	VCR	RF cable
		ANT-IN		(supplied)
		AUDIO OUT AUDIO IN
[Cable	box or satellite box] OR	L	L	UHF/VHF
		R	R
From Cable or		ANT-OUTVIDEO OUT	VIDEO IN

Satellite Company

RF OUTPUT CHANNEL for DVD/VCR

1.Connect the DVD/VCR COMBINATION UNIT to a TV using RF cable (see above steps).

2.Select channel 3 on your TV.

3.Press PLAY.

¡If noise appears, change the RF output channel of the DVD/VCR COMBINATION UNIT to channel 4 by pressing PLAY on the VCR side of the DVD/VCR COMBINATION UNIT (not the remote control) for 3 seconds during tape playback.

This will switch the DVD/VCR RF OUTPUT CHANNEL TO 4. ¡Turn your TV to channel 4.

Note

¡If the RF CHANNEL does not change, press STOP to stop the VHS tape playback, then press PLAY for 3 seconds. ¡If there is a power failure or the unit is unplugged for more than 30 seconds, the RF CHANNEL OUT will

return to channel 3.

Note to CATV system installer

This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that pro- vides guidelines for proper grounding and, in particular, specifies that the cable ground should be connected to the grounding system of the building, as close to the point of cable entry as practical.

CONNECTING TO A TV WITH A/V TERMINALS

Antenna/Cable signal

A/V-compatible or wide screen TV

DVD/VCR	VCR
AUDIO OUT	AUDIO IN
ANT-IN
L	L

R R

ANT-OUTVIDEO OUT VIDEO IN

DVD

S-VIDEO COMPONENT	AUDIO	DIGITAL
OUT VIDEO OUT	OUT	AUDIO OUT
Y
Cb	L
		COAXIAL OPTICAL
Cr	R

To ANT. IN

of TV
To VIDEO INPUT jack To VIDEO OUT jack
To Right (red) and Left (white)
To AUDIO INPUT jacks To AUDIO OUT jacks	[Fig. 1]

Notes

¡Connect the DVD/VCR COMBINATION UNIT directly to a TV. If the A/V cables are connected into a VCR first, picture may be distorted due to the copy protection system.

– 13 – EN

1L25