8-2
LS 9208 Product Reference Guide
Connecting to an IBM 468X/469X Host
This connection is made directly from the scanner to the host interface.
Figure 8-1. IBM Direct Connection
1. Connect the interface cable to the rear of the scanner, as described in Installing the
Interface Cable on page 1-3.
2. Connect the other end of the interface cable to the appropriate port on the host
(typically, Port 9).
3. Scan the appropriate bar codes in this chapter to configure the scanner.
Note:The only required configuration is the port number. Most other
scanner parameters are typically controlled by the IBM system.
Host Port Connector
Interface cable