Symphonic SD7S3 owner manual Hookups, Connecting to a TV Without A/V Terminals

HOOKUPS

CAUTION:

¡Be sure to turn off the DVD/VCR COMBINATION UNIT and equipment to be connected. ¡Read through the operation manual for the equipment to be connected.

¡Be sure that the colors of the jacks and plugs match up when using VIDEO/AUDIO cables.

¡Be sure to keep the DVD/VCR COMBINATION UNIT connection cables separate from the TV antenna cable when you install the DVD/VCR COMBINATION UNIT, because it may cause electrical interference when you are watching television programs.

CONNECTING TO A TV WITHOUT A/V TERMINALS

1.Disconnect the AC power cord of the TV from the AC outlet.

2.Disconnect the antenna or cable from the TV.

3.Connect the antenna or cable to the ANT-IN jack of the DVD/VCR COMBINATION UNIT.

4.Connect the DVD/VCR COMBINATION UNIT to the TV using the RF cable.

5.Plug the AC power cords of the DVD/VCR COM- BINATION UNIT and TV into the AC outlets.

[VHF/UHF	[Indoor antenna]	[Back of the DVD/VCR]
combination antenna]			[Back of the
			UHF/VHF combination TV]
	OR	DVD/VCR	VCR RF cable
		ANT-IN	(supplied)
		AUDIO OUT
[Cable	box or satellite box] OR	L	UHF/VHF
		R	AUDIO IN

From Cable or	ANT-OUTVIDEO OUT
	VIDEO IN
Satellite Company

RF OUTPUT CHANNEL for DVD/VCR

1.Connect the DVD/VCR COMBINATION UNIT to a TV using RF cable (see above steps).

2.Select channel 3 on your TV.

3.Press PLAY.

¡If noise appears, change the RF output channel of the DVD/VCR COMBINATION UNIT to channel 4 by pressing PLAY on the VCR for 3 seconds during playback.

¡There is case that the RF output channel does not change by situation (For example, when you adjust tracking using CHANNEL () ).

In this case, stop the playback, and start the playback again. After that, press PLAY on the VCR for 3 seconds.

¡If there is a power failure or the DVD/VCR COMBINATION UNIT is unplugged for more than 30 seconds, the RF output channel setting will return to CH3.

Note to CATV system installer

This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that pro- vides guidelines for proper grounding and, in particular, specifies that the cable ground should be connected to the grounding system of the building, as close to the point of cable entry as practical.

CONNECTING TO A TV WITH A/V TERMINALS

	DVD/VCR	VCR			DVD
Antenna/Cable signal	AUDIO OUT		S-VIDEO COMPONENT AUDIO			DIGITAL
	ANT-IN		OUT	VIDEO OUT	OUT	AUDIO OUT
	L			Y
A/V-compatible or	ANT-OUTVIDEO OUT	AUDIO IN		Cb	L	COAXIAL
	R
wide screen TV		VIDEO IN		Cr	R
To ANT. IN
of TV
To VIDEO INPUT jack		To VIDEO OUT jack
To Right (red) and Left (white)						[Fig. 1]
To AUDIO INPUT jacks To AUDIO OUT jacks

Notes

¡Connect the DVD/VCR COMBINATION UNIT directly to a TV. If the A/V cables are connected into a VCR first, picture may be distorted due to the copy protection system.

– 13 – EN

1L25