STEP 1

ZEKTOR

1

2

3

 

 

 

 

STEP 2

ZEKTOR

1

2

3

STEP 3

ZEKTOR

1

2

3

 

 

 

 

1Place the MAS3 in standby mode. This is the factory default mode on power up, and if it has not been changed, you can unplug the MAS3 and plug it back in and it will power up in standby mode (at this point only the power indicator light is lit and glowing RED). If the MAS3 does not power up in standby mode, follow the steps given in "Restoring the MAS3 to Factory Defaults" on page 13.

2On your remote control press the buttons in the following sequence, after each button press verify that the remote IR indicator flashes. (If you make a mistake, you can start over by pressing POWER twice.):

•POWER

•CHANNEL +

•POWER

•CHANNEL -

3The MAS3 will power up indicating the new component codes have been accepted.

Searching for a component code in your remote

Assuming you do not have a remote listed in this user manual you will have to follow your remote controls programming sequences to find a compatible component that the MAS3 understands, or you can go to the section "Learning New Remote Codes" on page 8, to teach the MAS3 new keys for individual commands.

To search for compatible component codes you must place the MAS3 in standby mode and try manufacturer codes in your remote control until one of them causes the MAS3’s IR indicator LED to flash.

STEP 1

ZEKTOR

1

2

3

 

 

 

 

STEP 2

ZEKTOR

1

2

3

1Place the MAS3 in standby mode. This is the factory default mode on power up, and if it has not been changed, you can unplug the MAS3 and plug it back in and it will power up in standby mode (at this point only the power indicator light is lit and glowing RED). If the MAS3 does not power up in standby mode, follow the steps given in "Restoring the MAS3 to Factory Defaults" on page 13.

2Try different manufacturer codes until one of them causes the IR indicator light on the MAS3 to blink when pressing the POWERTOGGLE key. When found, go to back to "Teaching the MAS3 a new component code" on page 6, to teach the MAS3 to use the new component code.

7