Maintenance
NOTE: Before starting, notify the proper authorities that the smoke detector system is undergoing mainte- nance and, therefore, will be temporarily out of service. Disable the zone or system undergoing maintenance to prevent unwanted alarms.
The 1400 is cleaned as follows:
1.Remove the detector screen and cover assembly by depressing the three lock prongs on the top of the cover, rotating the cover clockwise, and pulling the screen cover assembly away from the detector (see Figure 5). Use of the System Sensor CRT400 cover removal tool is recommended.
2.Remove the screen from the cover.
3.Use a vacuum cleaner to remove dust from the screen, the cover, and the sensing chamber.
4.After cleaning, snap the screen into the cover, then place the cover and screen assembly on the detector turning clockwise until it is locked in place.
5.Test the detector as described in TESTING.
6.Notify the proper authorities that the system is back on line.
Figure 5. Removal of cover and screen for cleaning:
LOCKING
PRONGS
REMOVABLE
COVER FOR
CLEANING
REMOVABLE
SCREEN
LOCK PRONG
Please refer to insert for the Limitations of Fire Alarm Systems
System Sensor warrants its enclosed smoke detector to be free from defects in materials and workmanship under normal use and service for a period of three years from date of manufacture. System Sensor makes no other express warranty for this smoke detector. No agent, representative, dealer, or employee of the Company has the authority to increase or alter the obligations or limitations of this Warranty. The Company’s obliga- tion of this Warranty shall be limited to the repair or replacement of any part of the smoke detector which is found to be defective in materials or workmanship under normal use and service during the three year period commencing with the date of manufacture. After phoning System Sensor’s toll free number
Department, RA #__________, 3825 Ohio Avenue, St. Charles, IL 60174.
Please include a note describing the malfunction and suspected cause of failure. The Company shall not be obligated to repair or replace units which are found to be defective because of damage, unreasonable use, modifications, or alterations occurring after the date of manufacture. In no case shall the Company be liable for any consequential or incidental damages for breach of this or any other Warranty, expressed or implied whatsoever, even if the loss or damage is caused by the Company’s neg- ligence or fault. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This Warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
4 | ||
|
| ©2004 System Sensor |
