6.Insert the Check Valve into the outlet port
approximately 3/4" to 1" deep making sure the rubber diaphragm facing outward (towards you), see Diagram 1.
7. | Reconnect the return hose to the outlet port and |
|
|
| tighten the union fitting. |
|
|
8. | Replace the drain cap. |
|
|
|
| ||
9. | Remove the rag from the skimmer or open the |
|
|
| valve on the suction line. |
|
|
10. | If the return line was plugged, unplug it at this time. | Diagram1. | |
|
|
11.With the High Flow™ manual air relief valve in the
open position, start the filter pump, after a steady stream of water appears close the High Flow™ manual air relief valve.
12.Your system is now in operating order.
SECTION IV. INSTALLATION
To install this filter system, you will need the following simple tools - a screwdriver, pliers, and wrench.
1.Carefully remove the equipment from the carton and check for any evidence of damage due to rough handling or shipping. If any of the equipment is damaged, immediately notify the organization where the equipment was purchased.
2.Position a
3.This filter should be mounted on a level concrete slab, preferably concrete poured in a form or on a platform constructed of concrete block or brick.
4. Depending upon how your skimmer is positioned in | DetailC | |
| ||
relationship to the return fitting, see Diagram 3, either | Detail D | |
right or left of the skimmer, position the mounting base | ||
| ||
accordingly; see Diagram 3. Position the filter tank on |
| |
the mounting base so the filter inlet port is oriented |
| |
toward the pump similar to Diagram 2. Secure the filter |
| |
to the mounting base using two bolt fasteners. Place | DetailB | |
the pump on the mounting base; see Diagram 2. |
| |
Loosely attach the pump connector, see Detail A, to the | inlet | |
pump and filter. This will align the pump to the correct | ||
| ||
set of mounting holes. Secure the pump to the base |
| |
using two bolt fasteners. Tighten the union fittings on |
| |
the plumbing connector by hand until tight. If water |
| |
leakage occurs at these connections, adjust | Detail A | |
connections with a wrench making sure not to exceed 1/ |
| |
4 of a turn. | Diagram2. |
P/N 99101100 | 4 | REV. F |