5.Do not mount electrical controls (on/off switches, timer, etc.) over the filter. You need to be able to stand clear of the filter when starting the pump.
6.Attach the hair and lint pot to the front of the pump. This is an
7.Install the threaded fitting, see Diagram 3 – Figure 1, into the suction port of the pump. This is an
8.Install the threaded return fitting into the filter outlet port, see Diagram 3 – Figure 2, making sure that the
9.Connect black hoses to the equipment and the pool with the clamps provided.
a.Connect the skimmer suction port from the pool to the pump inlet.
b.Connect the filter outlet port to the return fitting of the pool, see Figure 1.
c.Install the High Flow™ air relief valve, see Diagram 2 – Detail C, into the top of the filter tank lid. This is an
d.Install the pressure gauge, see Diagram 2 – Detail D, using the Teflon tape provided. Wrap the threads of the pressure gauge with three layers. Install the gauge into the top of the filter tank until tight.
10.Never install a pump in this system that exceeds the maximum pressure of this filter,
see data label.
11.If using the optional Chlorinator Base, knockout the two slots on the system base with a hammer and screwdriver.
12.Slide the two tabs on the Chlorinator Base into the slots on the system base; see Diagram 4.
Figure 1. | Figure 2. |
Skimmer | Return |
| |
| POOL |
| To |
| Return |
| Fitting |
To |
|
Skim- |
|
mer |
|
Diagram3. | |
Slots
Tabs
Diagram4.
REV. F | 5 | P/N 99101100 |
