Settings | Quick |
Settings
➤Setting the tear position
This section describes how to set the tear position, the first printing line, the print head gap as well as the font selection and the character density.
If the tear position of the paper is not aligned with the tear edge of the top cover of the printer, you can adjust it.
Adjust Paperway
Menu Char
1 2 3 4
Online
Setup
Press the Setup key. The printer changes to setup mode. Press the Adjust (2) key.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| TOF |
|
|
| |
| Head |
|
|
|
| Tear |
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
1 | 2 | 3 | 4 |
| |||||
|
|
|
|
|
|
|
|
|
|
Press the Tear (4) key. The printer performs a form feed.
Online
Setup
Press the < (2) or > (3) key to move the perforation to the desired position.
TearAdj= 00/72"* Set < > Exit
1 2 3 4
Online
Confirm the input by pressing the Set (1) key.
Confirm the input again by pressing the Setup key. The printer is reset to the initial status.
Setup
The correction made – a maximum of approx. 2.5 cm (1") in each direction – will be retained after switching the printer off.
20