HV Series
Whole House Cooling Fans
Product Manual & Installation Guide
HVM.02
PLEASE LEAVE WITH HOMEOWNER
Serial Number _________ Date of Purchase __________Point of Purchase _________________
What the HV whole house cooling fans do
The HV is used to assist the natural cooling process in the house. When the outside temperature drops below the inside temperature, the cooler outside air can be used to cool the house. The HV will pull the cooler air from the outside, through the house, up into the attic and push the hot air outside. The HV is a fan product and will not cool the house below the outside air temperature or create a noticeable breeze. The HV can be used any time, for as long as needed, to cool or change the air in the house.
The best location for your HV
The HV should be located as central as possible to the area that you want to
HV1000cool. Above a central hallway or at the top of a stairwell provide the best airflow. The fan can also be mounted vertically, exhausting through a knee wall into an
Before installing your HV: Read all instructions carefully
►Some state and local electrical codes require fan products be installed by a licensed electrician. Check with your local code officials before installation.
►Make sure that you have adequate net free exhaust area out of your attic. A minimum of 2 square feet is required for the HV1000 and
►Make sure that there is enough clearance for the doors to open. Minimum requirement for the HV with R22 insulating doors (HV1000 and
►Make sure that there aren’t any pipes, wires, rafters, or air conditioning or heating ducts running through the space where the HV will be installed and that the doors will face an unoccupied area.
Unpacking your HV: When you have unpacked your HV carefully you will find the following:
HV1000 (silver faced insulation) | HV1600 (gold faced insulation) | ||
One (1) HV1000 Whole House Cooler | One (1) | HV1600 Whole House Cooler | |
One (1) White Metal Grille w/(6) Screws | One (1) White Metal Grille w/(6) Screws | ||
One (1) | Package of Foam Gasket | One (1) | Package of Foam Gasket |
One (1) | Metal Electrical Box Cover w/(2) Screws | Four (4) #8x3/4 Screws | |
One (1) Wall Switch (SPST) | One (1) | Hand Held Remote Transmitter | |
Four (4) #8x3/4 Screws |
|
| |
One (1) Grounding Screw (green) |
|
| |
DO NOT
PULL ON, CARRY BY OR STRESS THE DOORS
Please note the serial number, date of purchase and the point of purchase on the top of this page for handy reference. The serial number is located on a label affixed to the HV next to the junction/utility box.
©Tamarack Technologies, Inc.• 320 Main Street • Buzzards Bay, | MA 02532 |
www.tamtech.com |
