Owner’s Manual | |
|
Flexible drive shaft (Fig. 3-5)
Flexible drive shaft should be removed and lubricated with a good quality lithium grease every 20 hours. To remove the flexible shaft, first remove screw (1), loosen bolt (2) and remove the gear case then pull the shaft out of the drive shaft pipe. Clean the shaft off and apply a generous coat of lithium grease to it and insert if back into the drive shaft pipe, turn it until it drops into place then install the gear case, and install & tighten screw (1) and screw (2).
Angle transmission (Fig. 3-5B)
Check the gear case for grease level about every 50 hours of operation by removing the grease filler plug on the side of case.
If no grease can be seen on the flanks of the gears, fill the transmission with a quality lithium based multipurpose grease up to ¾ full.
Do not completely fill the transmission.
Blade (Fig. 3-6)
WARNING!
Wear protective gloves when handling or performing maintenance on the blade.
•Use a sharp blade. A dull blade is more likely to snag and thrust. Replace the fastening nut if it is damaged and hard to tighten.
•When replacing blade, purchase one recommended by TANAKA, with a 25.4mm (one inch) mounting hole.
•When installing a saw blade (2), always face the stamped side up. In the case of a 4 tooth blade (1), it can be used on either side. Use correct blade for the type of work.
•When replacing a blade, use appropriate tools.
•When cutting edges become dull,
•Discard blades that are bent, warped, cracked, broken or damaged in any way.
NOTE!
When sharpening blade it is important to maintain an original shape of radius at the base of the tooth to avoid cracking.
13 |
