3. Assembly procedures
Drive shaft to engine (Fig. 1
Owner’s Manual
Loosen tube locking bolt (1) about ten turns so that the bolt tip will not obstruct drive shaft tube to be inserted. When inserting drive shaft tube, hold the tube locking bolt outward preventing inside fitting from obstructing as well.
Insert the drive shaft into the clutch case of the engine until the decal (2) on the drive shaft tube meets the clutch case.
NOTE!
If the pipe will not go in far enough this is because the shaft end is not lined up with the receiver. In this case, turn the drive shaft (at the opposite end of the pipe) while pushing the pipe toward the engine. Tighten the
Installation of handle
WARNING!
When you use steel/rigid blades on straight shaft trimmers or brush cutters, always use barrier bar (2) and shoulder harness with the loop handle. (Fig. 1
Attach the handle to the drive shaft tube with the angle towards the engine. Adjust the location to the most comfortable position before operation. Remove the handle bracket (1) from the assembly. (Fig. 1
Place the handles and attach the handle bracket with four bolts lightly. Adjust to appropriate position. Then fix it firmly with the bolts.
Put stop cords (3) and throttle wire (1) through protective tube (2), then unhook the hip pad. (Fig.
5 |
