Tanaka TBC-230B TBC-2211,TBC-2251,TBC-230/B, Throttle wire/stop cord, custsvc@tanaka-ism.com

TBC-2211,TBC-2251,TBC-230/B Owner’s Manual

Throttle wire/stop cord

Remove the air cleaner cover. (Fig. 1-4) Connect stop cords. (Fig. 1 -5)

Set outer receiver (1) (if so provided) into wire guide and put throttle wire through the outer receiver. (Fig. 1 -4)

Connect throttle wire end to carburetor. (Fig. 1 -6)

Cover throttle wire and stop cords together with protective tube provided up to air cleaner cover. (Fig. 1 -7)

Installation of blade guard (Fig. 1-8, 8B, 8C)

Install the blade guard on the drive shaft tube against angle transmission (2) / gear case (1). Tighten the guard bracket firmly so that the blade guard does not swing or move down during operation.

When using a trimmer head (2), locate the guard above the angle transmission. (Fig. 1-8D, 9B)

CAUTION!

Do not attempt to install metal blade on the curved shaft trimmer.

It is very dangerous.

CAUTION!

Some blade guards are equipped with sharp line limiters. Be careful with handling it.

www.tanaka-usa.com 6 custsvc@tanaka-ism.com