Owner’s Manual | |
| |
|
|
Starting
CAUTION!
Do not start if the pipe is obstructed by the ground or any other object. 1 .Set ignition switch (1) to ON position.
(Fig.
•Push priming bulb (4) several times so that fuel flows through return pipe (5) (if so equipped) (Fig.
•Move throttle lever to a
Note! (TBL-4610)
Model
To start or to stop the unit, ignore the switch operation from procedures in the manual. However, when starting the unit, move throttle lever to START position.
2.Set choke lever to CLOSED position (4). Fig.
3.Pull recoil starter briskly, taking care to keep the handle in your grasp and not allowing it to snap back. (Fig.
4.When you hear the engine want to start, return choke lever to RUN position (open). Then pull recoil starter briskly again.
NOTE!
If engine does not start, repeat procedures from 2 to 4.
5.After starting engine, allow the engine about
www.tanakapowerequipment.com | 6 |