Tanaka TPS-250PN, TPS-2501 owner manual Assembly procedures, Throttle wire/stop cord

Models: TPS-250PN TPS2501, TPS-2510, TPS250PF/PN, TPS-270PF/PN TPS-2510, TPS-2510, TPS-250PF/PN, TPS-270PF/PN TPS-2501

1 17
Download 17 pages 16.2 Kb
Page 5
Image 5
3. Assembly procedures

TPS-2501,TPS-2510.TPS-250PN,TPS-270PN Owner’s Manual

3. Assembly procedures

Drive shaft to engine (Fig. 1 -1)

Loosen tube locking bolt (1) about ten turns so that the bolt point will not obstruct drive shaft tube to be inserted. When inserting drive shaft tube, hold the tube locking bolt outward preventing inside fitting from obstructing as well.

Insert the drive shaft into the clutch case of the engine properly until the marked position (2) on the drive shaft tube meets the clutch case.

NOTE!

When it is hard to insert drive shaft up to the marked position on the drive shaft tube, turn drive shaft by the cutter mounting end clockwise or counterclockwise. Tighten tube locking bolt lining up the hole in the shaft tube.

Then tighten clamp bolt securely (3).

Cutting attachment to drive shaft (Fig. 1-2)

Loosen tube locking bolt (1).

Insert the drive shaft into the gear case of the attachment properly until the marked position (2) on the drive shaft tube meets the gear case.

NOTE!

When it is hard to insert drive shaft up to the marked position on the drive shaft tube, turn attachment clockwise or counterclockwise.

Tighten tube locking bolt lining up the hole in the shaft tube. Then tighten clamp bolt securely (3).

Installation of handle (Fig. 1-3)

Attach the handle to the drive shaft tube with the angle towards the engine.

Adjust the location to the most comfortable position before operation.

Throttle wire/stop cord

Remove air cleaner cover. (Fig. 1-4) Connect stop cords. (Fig.1 -5)

Connect throttle wire end to carburetor. (Fig. 1 -6)

Cover throttle wire and stop cords together with protective tube provided up to air cleaner cover. (Fig. 1 -7)

www.tanaka-usa.com

4

custsvc@tanaka-ism.com

Page 5
Image 5
Tanaka TPS-250PN, TPS-2501, TPS-2510, TPS-2510, TPS-250PF/PN, TPS-270PF/PN Assembly procedures, Throttle wire/stop cord