Video Communication Server Installation
1
1.Unpack the unit.
2.Remove the protective foil from the front panel.
2
TANDBERG recommends that if this product is mounted in a rack you use additional support accessories such as rack side support angles (rack angle brackets) or rack shelves due to the unit’s weight and depth.
Please contact your rack supplier to request the accessories best fitted for your rack.
1.Mount the rack ears and/or rubber feet, if applicable.
2.Turn the unit back on its feet or mount it in the rack.
3
1.Connect the serial cable from the DATA port on the VCS to the serial port on a PC.
2.Connect the Ethernet LAN cable from the LAN1 port on the VCS to your network.
6
192.168.0.100
The default IP Address of 192.168.0.100 will be visible in the display shortly after
4
To connect to the VCS from the PC, start a terminal emulator program on the PC and configure it to use the PC’s serial port as follows:
sä baud rate: 115200 bits per second
sä data bits: 8
sä parity: none
sä stop bits: 1
sä flow control (hardware and software): none
7The terminal emulator program on the PC will display the unit’s start up information, and after approximately 4 minutes you will get a login prompt. At the prompt:
1.Login with a username of admin and the password
TANDBERG.
2.Type Y to start the installation wizard.
3.Follow the prompts to set the password, IP protocol, IP Address, IP subnet mask, IP default gateway, ether- net speed, SSH and Telnet options.
When the installation wizard is finished, the following message will appear:
Setting other settings...
OK. The system must be restarted for new settings to take effect.
5 | I | I |
| 2 | 1 |
| o |
|
o
VGA
1.Connect the power cable and turn the power on using the power switch on the back right of the unit.
2.Press the soft power button on the back left of the unit.
8
Restart the system as follows:
1.Login with the username admin and your new password.
2.Press Enter to skip the installation wizard.
3.Reboot the system by typing the command xcommand boot.
4.Disconnect the serial cable.
Once the system has restarted you are now ready to begin configuring and using your TANDBERG Video Communication Server. Please refer to the CD that was shipped with your unit for full documentation.
116347 rev. 6
