Tappan 318200505 manual Cleaning the Appliance Continued, To Remove and Replace the Oven Door

Cleaning the Appliance (Continued)

What to Expect During Cleaning

While the oven is in operation, the oven heats to temperatures much higher than those used in normal cooking. Sounds of metal expansion and contraction are normal. Odor is also normal as the food soil is being removed. Smoke may appear through the oven vent, located on the top of the control panel.

If heavy spillovers are not wiped up before cleaning, they may flame and cause more smoke and odor than usual. This is normal and safe and should not cause alarm. If available, use an exhaust fan during the self-cleaning cycle.

NOTE: A smoke eliminator in the oven vent converts most of the soil into a colourless vapor.

Setting the Controls for a Clean Cycle

For the setting of the clean cycle, refer to the section on the timer or Electronic oven control.

To Remove and Replace the Oven Door

1.Open the door fully.

2.Pull up the lock located on both hinge supports and engage them in the hook of the hinge levers. You may have to apply a little downward pressure on the door to pull the locks fully over the hooks.

3.Grab the door by the sides, pull the bottom of the door up and toward you to disengage the hinge supports.

Keep pulling the bottom of the door toward you while rotating the top of the door toward the range to completely disengage the hinge levers.

4.Proceed in reverse to re-install the door. Make sure the hinge supports are fully engaged before unlocking the hinge levers.

Lock in normal position

Lock engaged for door removal

HINGE SLOT Door removed from the range

To Remove/Replace Storage Drawer (some models)

To Remove/Replace the Storage Drawer with Rollers

Storage

Drawer

Rails

Roller

Front Frame

To Remove the Drawer

1.Pull the empty drawer out to the roller guide stop.

2.Tilt the drawer up and pull it out over the rollers.

To Replace the Drawer

1.Insert the rear end of the drawer into the opening.

2.Fit the drawer end rollers onto the guide rails.

3.Push the drawer in until it stops; lift to allow the rollers to clear the roller guide stop; push in.

To remove and replace decorative drawer front panel (some models)

1.To remove decorative front panel, insert fingers in top groove and pull out to disengage from clips.

2.To replace, first align slots of decorative front panel with clips located at bottom of range and push

back into its original position.

General 12 information