2 − Names and Functions of Parts
Rear panel
wDIRECT INPUT jacks
These direct input connectors provide direct line inputs for each channel.
eFOLDBACK output connectors
These output the input signals (INPUT 1 and 2) unchanged.
NOTE
When input is through INPUT 2’s unbalanced RCA pin jacks, the nominal output level is converted to balanced +4 dBu.
rINPUT 2 XLR connectors
These XLR connectors are balanced line inputs for INPUT 2.
(1: GND, 2: HOT, 3: COLD)
tINPUT 2 RCA jacks
These RCA pin jacks are unbalanced line inputs for INPUT 2.
NOTE
oPower connector
Use the included power cord to connect the power source.
CAUTION
When using this unit, always use the included power cord. Moreover, do not use the included power cord with any other equipment. Misuse of a power cord could cause malfunction, fire or electric shock.
pGround lift (GND LIFT) switch
Even when the ground connector is used to ground the unit, this ground connection can be interrupted (ground lift) by setting the GND LIFT switch to the left.
Signals should not be input to both the XLR and the RCA connectors at the same time. Use either the XLR or the RCA connectors for input.
yINPUT 1 XLR connectors
These XLR connectors are balanced line inputs for INPUT 1.
uINPUT 1 TRS jacks
These TRS jacks are balanced line inputs for INPUT 1.
NOTE
Signals should not be input to both the XLR and the TRS connectors at the same time. Use either the XLR or the TRS connectors for input.
iSignal ground (SIGNAL GND) connector
Use a commercially available
6 TASCAM