Tatung TBM-0903, TBM-1403, TBM-2003, TBM-1503, TBM-1203, TBM-1703 Fcc Information, Safety Precautions

Models: TBM-1503 TBM-1403 TBM-2003 TBM-0903 TBM-1203 TBM-1703

1 13
Download 13 pages 62.33 Kb
Page 3
Image 3
FCC INFORMATION

FCC INFORMATION

This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

Shielded interface cables and A.C. power cord, if any, must be used in order to comply with emission limits.

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

SAFETY PRECAUTIONS

1.Operate this unit only from the type of power source indicated on the label.

2.Do not block or cover ventilation openings on the back or bottom of the monitor cabinet.

3.Do not place this monitor near a radiator or heating vent.

4.Do not push objects of any kind through cabinet openings. This may result in fire or electrical shock.

5.Before adding attachments always ask a service technician to perform routine safety tests to determine that equipment is in safe operating condition. Ground potential tests should be part of the routine safety check made by the service technician.

6.Do not place monitor on an unstable cart, stand, or shelf where it may fall and injure personnel or damage equipment.

2

Page 3
Image 3
Tatung TBM-0903, TBM-1403, TBM-2003, TBM-1503, TBM-1203, TBM-1703 manual Fcc Information, Safety Precautions