14 Model BC12Operating Procedures
Step 6
Release the switch to stop the agitator.
Figure 21
Daily Cleaning
Taylor recommends daily cleani ng and
sanitizing.
ALWAYS FOLLOW LOCAL HEALTH CODES
Step 1
Prepare a sink with an approved cleaning solution
(examples: Kay-5ror Stera-Sheenr). USE HOT
WATER (110_F/43_C) AND FOLLOW THE
MANUFACTURER'S SPECIFICATIONS. Do not
use a solution that containsammonia and avoid
placing componentsin adishwasher.
Step 2
Disconnect power from the wal l
receptacle before performing th e following
steps. Failure to comply may result in electrical
shock.
Step 3
Remove the splash guard by squeezing the sides
until it is clear of the top pivot pins and then pulling it
out. Take it to the sink for cleaning and sanitizing.
Figure 22
Step 4
Wash the splash guard in the approved cleaning
solution.
Step 5
Wipe clean all stainless steel surfaces with an
approved, non-abrasive commercial cleaner. This
includes the mixer, dispenser, and organizer
surfaces.
Step 6
Clean sticky switches with a clean cloth, dampened
with cleaning solution. Clean around the edges of
the switch paddles until they function freely. W ork
the switches back and forth a few times to loosen
any dried residue under the switch. Dry the switches
withasoftcottoncloth.
Note: Leaving the switches sticky will damage or
burn them out.
WARNING: Do not spray water or oth er
liquid around the motorchamber. Do not use
excess liquid around the switches, motor protector ,
power cords, or cord entry hole. Make certain all
areas in and around the motor are dry before
connecting power to the wall receptacle. Failure to
comply may cause equipment damage o r
personal injury due to electricshock.