Taylor 1380 instruction manual Back View, Problem Solving, Display Information

Back View

Keyhole

ºC/ºF Button

Battery

Compartment

Table stand

Placement:

Table stand –

Use to sit the base unit on a flat surface, such as a desk or countertop.

Keyhole –

Use to hang on a wall.

Problem Solving

1.If the LCD readout is faint, replace the batteries.

2.If temperatures do not display on the base unit or seem irregular: a) Check to see the cable is not crimped, severed or otherwise

damaged;

b) Relocate sensor probe if it is obstructed from weather condi- tions or in contact with an object that might affect temperature readings (hot metal object, snow, etc.)

c) Remove and reinstall all batteries, using new fully charged bat- teries;

d) Repeat set-up procedures;

3.If new batteries are faulty on the initial installation, install fresh batteries. If you did not notice the Low Battery icon warning and the product performed correctly after initial set up, the batteries have lost their charge. Replace the batteries (see To Power up Weather Forecaster).

Display Information

If the receiver unit does not receive a transmission from the sensor probe for 1 hour, the display will show dashes. Remove and reinstall all batteries and repeat set up procedures. Check to see that the cable is not crimped or severed and the sensor is not obstructed. Try various locations for the sensor probe if necessary.

Over- or under- temperature range displays:

If the temperature is outside the unit’s temperature range of -40°F to 158°F / -40°C to 70°C (with use of lithium batteries), the LCD will show “HH” (higher than the temperature range) or “LL” (lower than the temperature range). When temperatures are within the range, the readings will return. If necessary, relocate the sensor probe away from locations with extreme temperatures (such as snow or a hot surface).

7