Taylor 490 Section 5 Important: To the Operator

Model 490 Important: To the Operator

Section 5 Important: To the Operator

The “Mix Low” light is located on the front of the

machine. When the light is flashing, it indicates that

the mix hopper has a low supply of mix and should

be refilled as soon as possible. The Model 490

utilizes a “Mix Out” light. When flashing, it indicates

there is no mix in the hopper and the compressor

stops running until mix is replenished. This

eliminates possible damage to the beater, blades,

drive shaft and door.

The overload mechanism protects the beater motor

from an overload condition. Should an overload

occur, the overload mechanism will discontinue

machine operation. To properly reset the freezer,

place the control switch in the “OFF” position. Allow

the unit to cool. Place the control switch in the

“WASH” position and observe the freezer's

performance.

Note: If an overload condition occurs while the unit

is operating in the “AUTO” mode, the unit will not

return to the “AUTO” mode once the overload has

reset. The draw handle must be lifted before the unit

will return to AUTO. Likewise, if power is rest ored to

a unit following a power interruption, it is necessary

to raise the draw handle to resume “AUTO”

operation.

The overload is inherent in the beater motor. There

is no manual reset.