Taylor 490 Closing Procedures, Draining Product from the Freezing Cylinder

15
Model 490 Operating Procedures
090807
Step 4
Place the control switch in the “AUTO” position.
Rotate the draw valve and lift the draw arm to star t
the compressor. When the unit cycles off, the
product will be at serving temperature.
Figure 21
Step 5
Place the mix hopper cover in position.
Note: When drawing product, gently raise the draw
arm to the fully opened position.
Closing Procedures
To disassemble the Model 490, the following items
will be needed:
STwo cleaning pails
SSanitized stainless steel rerun can with lid
SNecessary brushes (provided with freezer)
SCleaner
SSingle service towels
Draining Product from the Freezing
Cylinder
Step 1
Place the control switch in the “OFF” posit ion.
Step 2
Remove the hopper cover, gasket, and air tube.
Take these items to the sink for cleaning.
Step 3
If local health codes permit the use of rerun,
place a sanitized, NSF approved stainless steel
rerun container beneath the door spout. Place the
control switch in the “WASH” position and raise the
draw arm. When all the product stops flowing from
the door spout, lower the draw arm and place the
control switch in the “OFF” position. Plac e the
sanitized lid on the rerun container and place it in
the walk-in cooler. See page 18 for instructions
regarding the proper use of rerun.
Note: Iflocal health codesDO NOT permit the use
ofrerun, the product mustbe discarded. Follow t he
instructions in the previous step, except drain the
product into a mix pail and properly discard the mix.
ALWAYS FOLLOW LOCAL HEALTH CODES.