On/Off Operation
1.Place the base unit as close as possible to the remote sensor. This
will ensureeasy synchronization between the base and remote.
After setup is complete ,keep the units within effective transmis-
sionrange (w ithin 200 feet).
2.Turn on the base unit first by press-
ing the On/Off button.The LCD
will turn on and the unit will beep.
3.Turn on the remote unit by pressing the On/Off
button(l ocatedon the back). The remote will
vibrate,beep andthe “ ”light will blink.
4.Set volumeon remote:Off–Low–High. The
volumeswitch is located on the top of the
remote.
5.The remote will automatically searchfor a
signalfrom the base. The remote’s ready light
“ ”will blink,indicating the remote is receiv-
ing asignal from the base. The ready light will
continueto blink every 8 seconds again indi-
catingthat the remote is receiving signals from
the base.
6.If transmission is interrupted, the ready light
will stop blinking and the remotewill vi-
brate3 times every 30 seconds.Tosynchro-
nize the units again,place the base and
remotenear each other and press and hold
the“ ”button located on the back of the
baseunit.
Press“On/Off” onbase unit
Press“On/Off” onremote
2
3
Selectvolume level
4
Greenlight =
transmissionOK
5
4
Nogreen light &
remotevibrates=
Press“ ”onbase
6