15
Model 632 Operating Procedures
081117
Section 6 Operating Procedures
We begin our instructions at the point where we enter
the store in the morning and find the parts
disassembled and laid out to air dry from the prev ious
night’s cleaning.
These opening procedures will show you how to
assemble these parts into the freezer, sanitize them,
and prime the freezer with fresh mix in preparation to
serve your first portion.
If you are disassemblingthe machine for the first time
or need information to get to this starting point in our
instructions, turn to page 25, “Disassembly”, and start
there.

Prior To Set--Up For Units With A

Syrup Rail (OptionalFeature)
Step 1
Remove the two stainless syrup jars with t opping
pumps from the syrup rail. Check the wat er level in the
heated syrup topping well. Make sure the water is filled
to the indicatingmark on the bottom of the well.
Step 2
Place the heater switch in the ON position.
Note: This heating process will take approximately
2--1/2 hours to reach temperature. The water level in
the topping wells must be checked at least once daily.
Step 3
Preparea pail of approved 100 PPM sanitizing solut ion
(examples: 2--1/2gal. [ 9.5 liters] of Kay--5Ror2 gal.
[7.6 liters] of Stera--SheenR). USE WARM WATER
AND FOLLOW THE MANUFACTURER’S
SPECIFICATIONS. Sanitize the topping pumps by
placing the entire pump assembly in the pail of sanitiz-
ing solution. Pump the solution through t he assembly
to thoroughly sanitize the pump.
Step 4
Remove the two topping pumps. Fill each stainless
syrup jar with topping. Replace the topping pumps in
the syrup jars.

Freezing Cylinder Assembly -- Soft

Serve Side

Note: When lubricating parts, use an approved f ood
grade lubricant (example: Taylor Lube).
MAKESURE CO NTROL SWITCH IS IN THE
“OFF” POSITION. Failure to do so may causeinjury
from hazardous moving parts, or electrocution.
Step 1
Install the drive shaft. Lubricate the groove and shaft
portion that comes in contact with the bearing on the
beater drive shaft. Slide the seal over the shaft and
groove until it snaps into place. DONOT lubricate t he
hex end of the drive shaft. Fill the insideportion of the
seal with 1/4” more lubricant and lubricate the flat side
of the seal that fits onto the rear shell bearing.
Figure 3