18
Operating Procedures Model 632
Slide the fork over the bar in the slot of the dr aw valve.
Secure with pivot pin.
Figure 14
Note: These units feature adjustable draw handles to
provide the best portion control. The draw handles can
be adjusted for different flow rates. See page 14 for
more information on adjusting these handles.
Step 7
Snap the design cap over the end of the door spout.
Figure 15
Step 8
Slide two o--ringson one end of t he air tube. Slide two
o--rings on the other end of the air tube.
Figure 16
Slide the small o--ringint o the groove of the air orifice.
Do not lubricate the o--ring.
Figure 17
Note: Make sure the hole in the air orifice is clean and
is not clogged. If the hole in the air orifice should
become clogged, use soap and hot water to clear the
hole. Do not enlarge the hole in the air orifice.
Install the air orifice into the hole in the top of the air
tube (in the end without the small hole on the side).
Figure 18
Step 9
Lay the air tube (with the air orific e installed) in the
bottom of the mix hopper for sanitizing.
Note: The air tube for the shake side does not require
o--rings or anair or ifice.